0755-82557621 sales@chiplinkstech.com Mon–Fri 09:00–18:00 (UTC+8)
Precision motion control · Components and solutions

How to Use the TMC5160-BOB and TMCL-IDE

1. Use TRINAMIC's MCU board Landungsbrücke and TMCL-IDE to debug the TMC5160-BOB. The TMC5160-BOB can be used in two different operating modes: internal motion controller mode and pulse/direction mode. Using Landungsbrücke […]

2020-05-29 Frequently Asked Questions
No cover image

1. Use TRINAMIC's MCU board Landungsbrücke and TMCL-IDE to debug the TMC5160-BOB.

The TMC5160-BOB can be used in two different operating modes: internal motion controller mode and pulse/direction mode.
Using Landungsbrücke and TMCL-IDE, the TMC5160's internal motion controller can be configured.
On the TMC5160-BOB, resistor R2 should be populated/soldered, while R1 should be omitted.

The original site image is no longer available; awaiting the original file.

2. ConnectWiring

only requires10 jumper wires.You can refer tothe TMC5160-BOB datasheet and the pin definitions in the TMC5160-EVAL user manual for wiring.

The image on the original site is no longer available; awaiting the original file to be added.

  2.1 Landungsbrücke Pin Definitions

The image on the original site is no longer available; awaiting the original file to be added.

2.2 Connections

Signal Landungsbrücke TMC5160-BOB
VCC_IO +5V_USB (5) VCC_IO (1)
TMC5160 DRV_ENN DIO_0 (8) DRV_ENN(9)
SPI Chip select (CS) CSN_DRV (30) CSN (3)
SPI CLK SPI1_SCK (31) SCK (4)
MOSI SPI1_SDI (32) SDI (5)
MISO SPI1_SDO (33) SDO (6)
STEP DIO_6 (17) REFL (10)
DIR DIO_7 (18) REFR (11)
TMC5160 CLK CLK16 (23) CLK (8)

 

2.3 Connecting TMCL-TDE

Open TMCL-IDE, select TMC5160-EVAL, and select velocity mode or position mode for control.

The image from the original site is no longer available; waiting for the original file to be supplied.

The image from the original site is no longer available; waiting for the original file to be supplied.

3. Using Pulse/Direction Mode

To use it in S/D mode, an external S/D generator is required. In this case, TMCL-IDE can be used to configure registers using the Register Browser.

For external S/D mode, the following items should be checked:

- Enable SD_MODE via TMCL-IDE
- Pull ENC_B down to GND
- Connect REFL/REFR to an external S/D generator.

The image on the original site is no longer available; awaiting the original file.

← Back to News